Car Pedal Kit

This dead pedal kit is only compatible with Mahindra New Thar 2020 Onward  Automatic Variant. made of steel material with powdered coated. ..

If the pedals still loose after installation, please check and install it again.If the pedals tangle with the mat or the sidewall, they will not work well and even bounce back. At that time, you should loosen screws to remove pedals.Between the pedals and sidewall, keep no less than 5 mm space, so that the pedals can work freely and it can avoid dangers.Please check your pedal size before buying.Package Includes:1 x Accelerator Pad Cover1 x Brake Pedal Cover1 x Clutch Pedal Cover1 set of Screws Accessories..

If the pedals are still loose after installation, please check and install it again.If the pedals tangle with the mat or the sidewall, they will not work well and even bounce back. At that time, you should loosen the screws to remove the pedals.Between the pedals and sidewall, keep no less than 5 mm space, so that the pedals can work freely and it can avoid dangers.Please check your pedal size before buying.Installation1.  For Bracket Installation Use the L-shaped brackets.attached the L-shaped brackets onto the aluminium pedal. Align the aluminium pedal onto the top of the original pedal, rotate the L brackets so they grab onto the backside of the original pedal, and then firmly tighten the screw/nuts. 2. For Permanent Installation  Drill bit required (1/8"). (Drill bit not included)Pry the rubber cover from the top of the original pedal  Align the aluminium pedal onto the top of the original pedal, drill a 1/8" hole for each mounting hole as needed to secure the pedal, and then firmly tighten the screwWarningdo not operate the vehicle barefoot or with slippers.Pedals have sharp edges that could cause injury to the foot.Before Installation park the car safely, take the key out of the ignition apply the parking brake.Check the pedal mechanism periodically to ensure that the pedal is secure and fits properly.Package Includes:1 x Accelerator Pad Cover1 x Brake Pedal Cover1 set of Screws Accessories..

If the pedals are still loose after installation, please check and install it again.If the pedals tangle with the mat or the sidewall, they will not work well and even bounce back. At that time, you should loosen the screws to remove the pedals.Between the pedals and sidewall, keep no less than 5 mm space, so that the pedals can work freely and it can avoid dangers.Please check your pedal size before buying.Installation1.  For Bracket Installation Use the L-shaped brackets.attached the L-shaped brackets onto the aluminium pedal. Align the aluminium pedal onto the top of the original pedal, rotate the L brackets so they grab onto the backside of the original pedal, and then firmly tighten the screw/nuts. 2. For Permanent Installation  Drill bit required (1/8"). (Drill bit not included)Pry the rubber cover from the top of the original pedal  Align the aluminium pedal onto the top of the original pedal, drill a 1/8" hole for each mounting hole as needed to secure the pedal, and then firmly tighten the screwWarningdo not operate the vehicle barefoot or with slippers.Pedals have sharp edges that could cause injury to the foot.Before Installation park the car safely, take the key out of the ignition apply the parking brake.Check the pedal mechanism periodically to ensure that the pedal is secure and fits properly.Package Includes:1 x Accelerator Pad Cover1 x Brake Pedal Cover1 set of Screws Accessories..